2. There are many elbows used on the inlet pipeline
3. The water pump inlet is directly connected to the elbow
This will cause uneven distribution of water flow through the elbow and into the impeller. When the diameter of the inlet pipe is greater than 143c at the water pump inlet, an eccentric reducer pipe should be installed. The flat part of the eccentric reducer should be installed above, and the inclined part should be installed below. Otherwise, air will accumulate, water output will decrease or water cannot be pumped, and there will be a sound of impact. If the diameter of the inlet pipe is equal to that of the water pump inlet, a straight pipe should be added between the water pump inlet and the elbow, and the length of the straight pipe should not be less than 2-3 times the diameter of the water pipe.?
4. The bottom section of the inlet pipe equipped with a bottom valve is not vertical
If installed in this way, the valve cannot close on its own, causing water leakage. The correct installation method is to install the inlet pipe with a bottom valve, and the bottom section should preferably be vertical. If vertical installation is not possible due to terrain conditions, the angle between the water pipe axis and the horizontal plane should be above 60 degree .
5. The water inlet position of the inlet pipe is incorrect
(1) The distance between the inlet of the inlet pipe and the bottom and wall of the inlet tank is less than the diameter of the inlet. If there is sediment and other pollutants at the bottom of the pool, and the distance between the water inlet and the pool bottom is less than 1.5 times the diameter, it will cause poor water intake or suction of sediment and debris during pumping, blocking the water inlet.
(2) When the inlet depth of the inlet pipe is not enough, it can cause vortices to form on the water surface around the inlet pipe, affecting the inlet and reducing the water output. The correct installation method is: the inlet depth of small and medium-sized water pumps should not be less than 300-600mm, and that of large water pumps should not be less than 600-1000mm.
6. The water outlet is above the normal water level of the water outlet tank

